Aptelisense - Compliance software
The Compliance server is supported on the following Operating Systems:
• Microsoft Windows Server 2008 (32 bit or 64 bit) service Pack 2 and above, running in 32 bit mode
The type of CPU, amount of memory and size of disk required will depend on the number of:
• Monitored servers
• Collectors required to monitor events
• Reactors required to analyze the collected events
• Rules in use by each Reactor
A typical installation monitoring 10 servers using 10 Collectors and 10 Reactors can run on the minimum CPU (see below) using as little as 150MB of RAM and 200MB of disk, however this will vary depending on the actual configuration.
x86 compatible or x86/64 compatible processor.
Minimum: dual 2.4GHz processor. Recommended: quad 2.4GHz (or higher) processor.
Minimum: 150MB of RAM. Recommended: 1 to 2 GB RAM.
Minimum: 200 MB. Recommended: 20 GB plus.
It is recommended that you install Aptelisense Compliance on a disk that has plenty of room to accommodate future growth of the Compliance database.
The Aptelisense Pro client is included with the Aptelisense Compliance product and is used to communicate securely with remote servers (where required).
The hardware requirements for Aptelisense Pro vary depending on the host system, but in general Aptelisense pro has a small foot print and requires approximately: less than 20MB of disk, 10MB or less of RAM and will run on a low powered single CPU
Aptelisense Pro is supported on the following Operating Systems:
• Microsoft Windows Server 2000 (32 bit only) service Pack 4 and above
• Microsoft Windows Server 2003 (32 bit or 64 bit) service Pack 2 and above, running in 32 bit mode
• Microsoft Windows Server 2008 (32 bit or 64 bit) service Pack 2 and above, running in 32 bit mode
• Microsoft Windows XP Professional (32 bit only) service Pack 3 and above
• Red Hat Enterprise Linux version 4 and above
• Ubuntu Linux version 7 and above
• Sun Solaris (SPARC) version 10
• HP-UX (PA-RISC) version 11i